Cabletron Systems W85 Manual De Usuario

Chapter 2: Installation

An HSIM-W85 can be installed in any Cabletron Systems device that 
supports HSIM technology (e.g., 2H252-25R, 2E42-27, 6E132-25).

The following subsections provide instructions for installing an 
HSIM-W85 in a host platform. Refer to the specific interface module or 
standalone device manual for exact HSIM slot and connector locations.

To install an HSIM-W85 in an interface module that supports HSIM 
technology, perform the following steps.

Note the ports of the interface module that have cables attached to 
them. Write down the ports and label the cables to make it easier to 
reattach the network properly after the installation. Then disconnect 
those cables from the ports.

Attach the antistatic wrist strap (refer to the instructions outlined on 
the antistatic wrist strap package).

If the interface module is installed in a chassis, unlock the top and 
bottom plastic locking tabs of the module faceplate.

Remove the module from the chassis, and place it down flat with the 
internal components facing up.

Remove and save the two faceplate mounting screws securing the 
HSIM coverplate and remove the coverplate. See 

.

Only qualified personnel should install or service this unit.

Refer to the release notes for the version of firmware running 
on the Cabletron Systems host platform to ensure that the 
HSIM-W85 is supported.