Cabletron Systems WPIM-RT1 Manual De Usuario

 

This chapter describes steps for operation of the WPIM-RT1. It also 
briefly explains WPIM-RT1 features, ISDN, and indicates where to find 
the WAN protocols supported by the WPIM-RT1. 

Some of the steps for successful operation of this device are:

 

Install the WPIM-RT1 in a Wide Area Network host platform. Refer to 

 for direction on installation procedures. Refer to the 

appropriate host platform manual (i.e., the Cabletron Systems

 

for other 

installation and troubleshooting procedures.

 

Set up and access Local Management. Refer to the appropriate host 
platform User’s Guide for instructions on setting up and accessing 
Local Management. Refer to 

 for Local Management 

information for the HSIM-W6 and the CSX400. Refer to the Cabletron 
Systems 

 

 for information on setting up the 

WPIM-RT1 using management with the HSIM-SSA710.

 

Configure the device. Due to the automation of setup features, it is 
strongly recommended to use the Graphical User Interface QuickSET.

 

The device in which the WPIM-RT1 is to be installed may be 
referred to as the host platform in this documentation.

QuickSET is the desired method for configuring the 
WPIM-RT1. Check the Release Notes for the availability of 
QuickSET for configuration. 

Refer to 

 to use Local Management to configure the 

WPIM-RT1 for the CSX400 and the HSIM-W6, if QuickSET is 
not available. Refer to the Cabletron Systems 

 

HSIM-SSA710 

User’s Guide

 

 to configure the WPIM-RT1 if the HSIM-SSA710 

is the host platform.