Cabletron Systems SWPIM-BRI Manual De Usuario

 

This guide is organized as follows:

This 

 

provides preliminary information that will aid in using 

this manual, lists technology and user’s guides that may help the user to 
set up and manage the SWPIM-BRI, gives an overview of the 
SWPIM-BRI and its features, and information on how to get help from 
Cabletron Systems. 

 

, provides instructions on how to install the device 

into a host platform, and gives the LED indications.

 

, contains information on functionality and 

operating specifications, connector pinouts for the SWPIM-BRI, 
environmental requirements, and physical properties.

 

, explains the FCC rules 

for the SWPIM-BRI.

 

The SWPIM-BRI is installed into any Cabletron Systems product that 
supports the SWPIM architecture, such as the SSR-600, or the 
HSIM-SSR-600.

The SWPIM-BRI uses a single RJ48 connector supporting the 
S/T-interface and the U-interface. There are two different pin assignments 
and cables for the two interfaces. Refer to Appendix A for the Cabletron 
Systems part numbers and pin assignments for these cables.

The S/T-interface is provided via a four-wire Integrated Services Digital 
Network (ISDN) Basic Rate Interface (BRI), while the U-interface is 
provided via a two-wire ISDN BRI.

The SWPIM-BRI provides support for the transportation of two 64 Kbps 
Bearer (B) channels and one 16 Kbps Data (D) channel for a total of 
144 Kbps. The SWPIM-BRI can be configured by software to select the 
S/T-interface for terminal equipment (TE) mode or the U-interface for 
network termination (NT) mode. Refer to the host platform software 
user’s manual for information on how to configure the SWPIM-BRI using 
software.

The SWPIM-BRI has two LEDs, to indicate link and status conditions. 
Refer to Chapter 1 for more details.