Avocent DSR2035 Manual De Usuario
Chapter 2: Installation 11
Verifying the Connections
DSR2035/8035 switch
The front panel of the DSR2035/8035 switch features LEDs indicating the Ethernet connection for
both LAN1 and LAN2:
both LAN1 and LAN2:
•
The green LED, labeled Link, illuminates when a valid connection to the network is
established at a rate of 1000 Mbps and blinks when there is activity on the port.
established at a rate of 1000 Mbps and blinks when there is activity on the port.
•
The amber LED illuminates when you are communicating at a rate of 100 Mbps when using an
Ethernet connection.
Ethernet connection.
•
If neither LED is illuminated, connection speed is at a rate of 10 Mbps.
Additionally, the front panel of the DSR2035/8035 switch has LEDs for each port that indicate the
target device status:
target device status:
•
A green LED illuminates when the attached target device has power.
•
An amber LED illuminates when that port is selected.
•
The LEDs blink during a firmware upgrade.
DSRIQ modules
NOTE: PS/2, Sun, USB, USB2 and USB2L DSRIQ modules are available for attaching servers to your DSR
switch. If your DSR switch supports virtual media, connect virtual media devices to a workstation using USB2
and USB2L DSRIQ modules.
switch. If your DSR switch supports virtual media, connect virtual media devices to a workstation using USB2
and USB2L DSRIQ modules.
Use the DSRIQ-SRL serial module to connect serial devices to the DSR2035/8035 switch. The
DSRIQ-SRL module features two green LEDs: a POWER LED and a STATUS LED.
DSRIQ-SRL module features two green LEDs: a POWER LED and a STATUS LED.
•
The POWER LED indicates that the attached DSRIQ-SRL module is powered.
•
The STATUS LED indicates that a valid selection has been made to a DSR2035/8035 switch.
The DSRIQ-SRL module prevents a serial break from the attached device if the module loses
power. However, a user can generate a serial break with the attached device by pressing
power. However, a user can generate a serial break with the attached device by pressing
Alt-B
after
accessing the Terminal Applications menu.
Configuring the Web Server and DSView 3 Software
Because the DSR2035/8035 switch has an on-board web server, you must configure the web server
and install the DSView 3 software.
and install the DSView 3 software.
Setting up the built-in web server
You can access the DSR2035/8035 switch via an embedded web server that handles most day-to-
day switching tasks. Before using the web server to access the switch, first specify an IP address
day switching tasks. Before using the web server to access the switch, first specify an IP address