3com 4000 Manual De Usuario
Console Port
B-5
2 Verify that the AccessBuilder IP address and default router address have
been properly configured (see TABM on-line help or the optional
AccessBuilder Software Configuration Guide).
AccessBuilder Software Configuration Guide).
3 If you are updating from software version 5.0 or above, use the Load
command followed by the desired filename, followed by the TFTP
server’s IP address. For example:
server’s IP address. For example:
\> load absrvr 192.142.72.80
Where 192.142.72.80 is the IP address of the TFTP server.
The AccessBuilder server then resets and resumes normal operation.
The download/upload procedure is now complete.
In the event a TFTP image download fails, perform steps 4 through 8 of
the Console Port Download procedure (page B-9).
the Console Port Download procedure (page B-9).
Console Port
Download/upload operations may also be performed through the
AccessBuilder’s console port. Two methods may be used:
AccessBuilder’s console port. Two methods may be used:
■
On-site, a local PC running a terminal emulator is attached to the
console port,
console port,
■
Remotely, the same as above but with modems in between.
This technique is based on using a PC with a terminal emulator (using
the Windows X-Modem file transfer protocol) to either directly connect
to the local AccessBuilder’s console port, or initiate a call into the
remote AccessBuilder 4000’s console port. Once connected to the
AccessBuilder’s command line interface, an appropriate transfer
command may be issued to perform the desired upload/download
function.
the Windows X-Modem file transfer protocol) to either directly connect
to the local AccessBuilder’s console port, or initiate a call into the
remote AccessBuilder 4000’s console port. Once connected to the
AccessBuilder’s command line interface, an appropriate transfer
command may be issued to perform the desired upload/download
function.
ab4kbook Page 5 Thursday, March 27, 1997 11:51 AM