3com 3CR990-TX-95 Manual De Usuario
Installing From Diskette
5
This guide explains installing network drivers from floppy
diskettes for the 3Com
diskettes for the 3Com
®
EtherLink
®
10/100 PCI network
interface card (NIC) with 3XP processor (3CR990 family). It
is intended to be used with computers that are not
equipped with a CD-ROM drive.
is intended to be used with computers that are not
equipped with a CD-ROM drive.
For complete instructions about EtherLink 10/100 PCI NIC
hardware installation, configuration, and troubleshooting,
see the EtherLink 10/100 PCI Network Interface Card with
3XP Processor User Guide (P/N 09-1742-001).
hardware installation, configuration, and troubleshooting,
see the EtherLink 10/100 PCI Network Interface Card with
3XP Processor User Guide (P/N 09-1742-001).
You can print the Adobe Acrobat Reader Portable
Document Format (PDF) version of this guide for reference.
It is available on the EtherCD
Document Format (PDF) version of this guide for reference.
It is available on the EtherCD
™
in the following location:
\english\manuals\etherdsk\usrguide.pdf
Installing From Diskette
If your computer does not have a CD-ROM drive, use a PC
that has a CD-ROM drive and create installation diskettes
from the EtherCD.
that has a CD-ROM drive and create installation diskettes
from the EtherCD.
You can also download the EtherDisk software from the
3Com World Wide Web site:
3Com World Wide Web site:
http://support.3com.com/infodeli/tools/nic
The installation diskettes allow you to install the network
driver only. If you want to install the NIC diagnostics or
desktop management software, you must install them from
the EtherCD.
driver only. If you want to install the NIC diagnostics or
desktop management software, you must install them from
the EtherCD.
Making a DOS-Bootable Diskette
For installation and configuration procedures that require
you to boot from DOS, you cannot successfully use the
MS-DOS prompt from within Windows. Perform a “clean”
boot from DOS or use a DOS boot disk.
you to boot from DOS, you cannot successfully use the
MS-DOS prompt from within Windows. Perform a “clean”
boot from DOS or use a DOS boot disk.
To use the CD-ROM drive on a PC or server in a DOS
environment, the DOS drivers for the CD-ROM drive must
be installed. Consult the documentation that accompanied
your CD-ROM drive or your motherboard for information
about how to install these drivers.
environment, the DOS drivers for the CD-ROM drive must
be installed. Consult the documentation that accompanied
your CD-ROM drive or your motherboard for information
about how to install these drivers.
If the PC or server is only running DOS and a CD-ROM
drive is not installed, you must install the NIC software
drive is not installed, you must install the NIC software