Toshiba XVR16-60-X Manual De Usuario
19
LOOPING OUTPUTS
The 16 Channel XVR unit may have up to 16 Looping outputs. Depending on the destination of the outputs, each output may have to
be terminated. The outputs are located on the BNC Connector Cable. Attach the cable to the input for the BNC Connector Cable
highlighted below.
be terminated. The outputs are located on the BNC Connector Cable. Attach the cable to the input for the BNC Connector Cable
highlighted below.
The Video inputs are 75Ώ BNC connectors. Make sure there is a video source connected to the input and then connect a cable to the
Channel Out. The looping outs can be connected to video monitors or combined with adapters to connect to VCR’s.
Channel Out. The looping outs can be connected to video monitors or combined with adapters to connect to VCR’s.
LOOPING OUTPUT TERMINATION
When terminating the outputs becomes necessary, the XVR unit has built in termination that allows you to select individual outputs to
terminate individually. It is not always necessary to terminate the output when using it. It is dependant on the device with which you
are connecting it to. As a rule, if the image appears distorted or virtually unviewable, it most likely needs to be terminated.
terminate individually. It is not always necessary to terminate the output when using it. It is dependant on the device with which you
are connecting it to. As a rule, if the image appears distorted or virtually unviewable, it most likely needs to be terminated.
16 Channel
Always leave the dipswitch set to the ON position when the Looping Outputs are not used.
ON
Not connected to a monitor (Normal)
OFF
Connected to a monitor (Looped)