Philips 1314L2S Prospecto

NOTE: Other World Computing declares that this processor upgrade 

has been tested and found to comply with the limitations of a Class B 

digital device, pursuant to Part 15 of the FCC Rules & Regulations. These 

limits are designed to provide reasonable protection against harmful 

interference in a residential installation. This equipment generates, 

uses and can radiate radio frequency energy and, if not installed in 

accordance with these instructions, may cause harmful interference to 

radio communications. However, there is no guarantee that interference 

will not occur in any one particular installation, If this equipment does 

cause harmful interference to radio or television reception, this can be 

determined by turning the equipment this upgrade is installed into on and 

off. If this is determined to be the cause of harmful interference, the end 

user is encouraged to attempt to correct the interference by one or more 

of the following procedures:

• Connect the equipment to another electrical outlet, or use a line fi ltering 

device between the outlet and the computer

• Move the location of the receiving device and the computer

• Reorient the receiving antenna

• Increase the distance separating the receiver and the computer

Installation of the processor daughtercard is the same on all 

systems, simply align the 3 screw holes in the card and gen-

tly place over the logic board. Gently but fi rmly press straight 

down on the two rearmost screwholes until you feel the card 

“click” into place. Insert the included screwdriver and tighten 

the encapsulated 3 Phillips screws into the 3 screw holes. 

You’re all done - Enjoy your new processor!

Remove the protective cap from the OWC Mercury Extreme 

G4 processor upgrade. The cap is located on the bottom of 

the card, between the screw holes. Place the cap onto the 

processor card you just removed.

Place your fi ngers gently underneath the edge of the 

processor daughtercard, and with your fi ngertips, pull straight 

up. Do not pull at an angle, you risk breaking the processor 

socket if you don’t pull straight up. 

• 

Make certain you updated the fi rmware to version 4.2.8. If you did not, 

you will have to reinstall your original processor and boot into Mac OS 9 

to perform this task.

• Press the reset button marked “S1” on the logic board. This is located 

on the corner of the logic board near the PCI slots on most machines. 

You will need to reset your date & time settings as well as any AppleTalk 

settings after doing this.

• Reset the PRAM on your computer by pressing and holding the 

command - option - P and R keys at startup until the machine chimes 

3 times. You will need to reset your date & time settings as well as any 

AppleTalk settings after doing this.

• 

Final Cut Pro requires a valid speed to be reported correctly by Apple 

System Profi ler. For detailed instructions about this issue, please visit our 

tech center at: http://eshop.macsales.com/tech_center/index.cfm

This page also includes a full switch setting chart for your convenience.

• The OWC Mercury Extreme G4 supports hard disk and display sleep in 

all confi gurations. With some system confi gurations, deep sleep may not 

be supported.

Sales: 800.275.4576 

International: 815.338.8658 

Customer Service: 800-275-4576 

Tech Support: 815-338-8685

24hr Fax: 815.338.4332 

http://eshop.macsales.com/Service/Tech.cfm

Sales & Technical Support Hours (CST) 

8:30AM-8PM Monday - Friday 

10AM-4PM - Saturday

8:30am-5:30pm Monday - Friday 

Other World Computing 1004 Courtaulds Drive Woodstock, IL 60098

There is no need to modify the settings on the accelerator as 

they are preset for maximum performance from the factory. 

If you wish to adjust, please follow this chart.

 See Troubleshooting section for Final Cut Pro issues.