PioneerPOS G24-LC Manual De Usuario
Chapter 3: AT Commands Reference
April 15, 2008
G24-L AT Commands Reference Manual
3-205
Example
ats100?
001
OK
ats100=0
OK
ats100?
000
OK
+MSCTS, Enable/Disable CTS During Wakeup Period
This command defines the behavior of the CTS line when the G24-L is in normal mode (not
Sleep mode).
Sleep mode).
The command configures the G24-L CTS line behavior always to follow the flow control
requirements, or to follow it only if the terminal initiated a serial transmission session. This saves
the terminal from following the CTS interrupt every time the G24-L exits Sleep mode for internal
G24-L reasons (non-terminal communication related reasons).
requirements, or to follow it only if the terminal initiated a serial transmission session. This saves
the terminal from following the CTS interrupt every time the G24-L exits Sleep mode for internal
G24-L reasons (non-terminal communication related reasons).
Table 3-137: Command parameters
<Parameter>
Description
Remarks
<delta>
Time interval between one burst of sent/received
data to the other before the terminal enters sleep
mode.
0 : Wakeup out feature isn't active. (default when
+S100 set command is never used)
1 - 255: Time in seconds.
data to the other before the terminal enters sleep
mode.
0 : Wakeup out feature isn't active. (default when
+S100 set command is never used)
1 - 255: Time in seconds.
This value is saved on power
down.
down.
Command
Type
Syntax
Response/Action
Remarks
Set
AT+MSCTS=<control>
OK
The Set command tells the G24-L
whether to activate the CTS when the
unit is awakening.
whether to activate the CTS when the
unit is awakening.
Read
AT+MSCTS?
+MSCTS: <current
control>
OK
The Read command returns the current
control value.
control value.
Test
AT+MSCTS=?
+MSCTS: (list of
supported <control>)
OK
The Test command returns the possible
control values.
control values.