Nortel Networks 4050 Manual De Usuario
Chapter 11 Managing certificates 585
Nortel Secure Network Access Switch 4050 User Guide
To verify that the current certificate number is not in use by an installed
certificate, use the
certificate, use the
/cfg/cert #/show
command.
2
Copy the certificate.
a
In a text editor, open the certificate file you received from the CA.
b
Copy the entire contents, including the
-----BEGIN
CERTIFICATE-----
and
-----END CERTIFICATE-----
lines.
If the certificate file contains the private key as well, also include the
entire contents of the key, including the
entire contents of the key, including the
-----BEGIN RSA PRIVATE
KEY-----
and
-----END RSA PRIVATE KEY-----
lines.
3
Add the certificate.
a
Enter the following command:
/cfg/cert #/cert
b
Paste the certificate at the command prompt.
c
Press Enter to create a new line, and then enter an ellipsis (
...
) to
terminate.
d
If you are pasting in the private key at the same time, and if the key has
been password protected, you are prompted to enter the password phrase.
The password phrase required is the one specified when the key was
created or exported.
been password protected, you are prompted to enter the password phrase.
The password phrase required is the one specified when the key was
created or exported.
4
Apply the changes.
If you obtained the certificate by using the
/cfg/cert #/request
command to generate the CSR and are using the same certificate number, the
certificate is now fully installed.
certificate is now fully installed.
If you obtained the certificate by means other than using the
/cfg/cert #/
request
command to generate the CSR and are using a new certificate
number, you must now add the corresponding private key (see