Gateway E-826R Manual De Usuario
CHAPTER 5: Troubleshooting your Autoloader
www.gateway.com
66
Overview
This chapter describes various troubleshooting and diagnostic tools available
for use with the autoloader.
for use with the autoloader.
Caution
Only use the Diagnostics Commands
when the autoloader is known to be idle
and unavailable to host backup/restore
applications. Use of the Diagnostic
Commands from On-board Remote
Management should not be issued while
the autoloader is being used by host
applications. The autoloader recognizes
when the drive or autoloader are
executing host commands and responds
appropriately to prevent application
failures. A Diagnostic command being
issued between host application
commands may not be recognized
appropriately, resulting in a failed
application, such as a failed
backup/restore job.
The Power On Self Test (POST) and diagnostic tests are helpful tools for testing
the autoloader’s functionality and for troubleshooting errors. With the results
from the POST and diagnostic tests, you can determine how well the autoloader
is working and locate any problems.
the autoloader’s functionality and for troubleshooting errors. With the results
from the POST and diagnostic tests, you can determine how well the autoloader
is working and locate any problems.
The diagnostics section describes the POST and its various tests. This section
also explains how to perform diagnostic tests from the front panel and
On-board Remote Management.
also explains how to perform diagnostic tests from the front panel and
On-board Remote Management.
Safety guidelines
Warning
To avoid bodily injury, do not attempt to
troubleshoot your autoloader problem if:
troubleshoot your autoloader problem if:
- Power cords or plugs are damaged
- Liquid has been spilled into your server
- Your autoloader was dropped
- The case was damaged
Instead, unplug your autoloader and
contact a qualified computer technician.
If your autoloader was damaged during
shipment from Gateway, contact
Gateway Customer Care.
While troubleshooting your autoloader, follow these safety guidelines:
■
Never remove a magazine while your autoloader is accessing data or
backing up files.
backing up files.
■
Make sure that you are grounded correctly before working on the
autoloader.
autoloader.
Understanding POST
Every time you turn on the autoloader, the POST checks all of the autoloader’s
basic components. If you experience problems with the autoloader, the POST
is a good method to determine if any major parts are malfunctioning.
basic components. If you experience problems with the autoloader, the POST
is a good method to determine if any major parts are malfunctioning.
POST
Test Description
MICROP
Tests the microprocessor’s general-purpose registers.
IRAM
Tests the microprocessor’s internal RAM.
Addr Lines
Bit walks the SRAM address lines.
SRAM
Tests the 512 k SRAM.
Code Chksum
Verifies the Flash image checksum.
EERom
Checks the EERom area and verifies the checksums.