Gateway 7001 Series Manual De Usuario
100
www.gateway.com
Configuring the guest interface
To configure the Guest interface:
1
Do one of the following:
Configure the access point to represent two physically separate networks as described
in the following section, see
in the following section, see
.
OR -
Configure the access point to represent two virtually separate networks as described
in the following section, see
in the following section, see
.
2
Set up the guest welcome screen for the guest captive portal as described in the
following section, see
following section, see
.
Configuring a physically separate guest network
To configure a physically separate guest network:
1
Make two wired connections from the network ports on the access point: one to your
secure, internal LAN and the other to a guest network. (See
secure, internal LAN and the other to a guest network. (See
.)
2
Configure Ethernet (Wired) settings for physically separate internal and guest
networks on VLANs as described in the sections in
networks on VLANs as described in the sections in
.
Important
Guest Interface settings are not shared among access
points across the cluster. These settings must be
configured individually on the Administration pages for
each access point.
points across the cluster. These settings must be
configured individually on the Administration pages for
each access point.
To get to the Administration pages for an access point that
is a member of the current cluster, click on its IP Address
link on the Cluster > Access Points page of the current
AP.
is a member of the current cluster, click on its IP Address
link on the Cluster > Access Points page of the current
AP.
For more information about which settings are shared by
the cluster and which are not, see
the cluster and which are not, see