Linksys WAP54GPE Manual De Usuario

12

Chapter 4: Connecting the Wireless-G Exterior Access 

Point

This chapter explains how to mount and connect the Access Point. 

Depending on your application, you might want to set up the IP address of the device first before mounting the 
device. Refer to "Chapter 5: Setting Up the Wireless-G Exterior Access Point".

1. Locate an optimum location on a wall for the Access Point. Refer to the antenna pattern in "Chapter 3: Getting 

to Know the Wireless-G Exterior Access Point" to adjust the angle of the Access Point for your application.

2. Using the mounting plate as a template, mark the locations of the two wall-mount slots that are on the bottom 

of the mounting plate. Then, install a screw into each location.

3. Use four screws (included with the Access Point) to attach the mounting plate to the back panel of the Access 

Point.

4. Connect the included Category 5e Ethernet network cable to the Ethernet network port of the Access Point. 

Then, screw the connector cap tightly onto the port, so the Access Point has a water-resistant seal.

5. If you want to connect an optional, high-gain external antenna, unscrew the cap that protects the Type-N 

antenna port, then, connect your antenna cable to this port.