Linksys WPS54GU2 Manual De Usuario

5

Chapter 3: Connecting the PrintServer 

Before starting the physical installation, make a note of the PrintServer’s Default Name, which is located on the 
bottom of the PrintServer. There is a bar code sticker with an LK number printed on it (for example, LK71107). 
This number is used during the PrintServer driver installation. 

1. Plug one end of the Ethernet network cable into the PrintServer’s LAN port. (See Figure 3-1.)

2. Connect the other end of the cable to your networked hub, switch, or router. The distance between the 

PrintServer and the other device should not exceed 328 feet (100 meters). 

3. Use the USB cable to connect your USB printer to the PrintServer’s USB port. Plug the Type A connector end 

into the PrintServer (Figure 3-2) and the Type B connector end into the printer.

4. Use the parallel printer cable to connect your parallel printer to the PrintServer’s parallel port. Plug one end of 

the cable into the PrintServer (Figure 3-3) and the other end into the printer.

5. Power on your printer.

6. Plug the power adapter into the PrintServer’s Power port. (See Figure 3-4.)

7. Plug the power adapter into an electrical outlet.

NOTE: The PrintServer does not have an on/off 
power switch.  Whenever its power adapter is 
plugged into a power supply, the PrintServer is 
powered on. The PrintServer can be powered on 
before, during, or after your network is powered on. 

IMPORTANT: Make sure you use the power 
adapter supplied with the PrintServer. Use of a 
different power adapter could damage the 
PrintServer.