Lantronix EPS2-100 Manual De Usuario
TCP/IP Configuration
4 - 3
D. The IP address of the TFTP server you wish to use, if desired.
4.
Click OK.
5.
Cycle power on the server. EZWebCon will let you know whether the configuration was
successful.
successful.
4.1.2 Using a Directed Ping Packet
The ARP/ping method is available under UNIX, Windows 95, and Windows NT. If the EPS has
no IP address, it will set its address from the first directed IP packet it receives.
no IP address, it will set its address from the first directed IP packet it receives.
NOTE: The ARP/ping method only works during the first two minutes of EPS
operation. After two minutes, an alternate method must be used or the
EPS must be rebooted.
EPS must be rebooted.
On a UNIX host, create an entry in the host’s ARP table and substitute the intended IP address
and the hardware address of the server, then ping the server. This process typically requires
superuser privileges.
and the hardware address of the server, then ping the server. This process typically requires
superuser privileges.
# arp -s 192.0.1.228 00:80:a3:xx:xx:xx
% ping 192.0.1.228