Delta Electronics DOP-A Series Manual De Usuario

Chapter 4  Macro Function|ScrEdit Software User Manual 

Revision Apr. 30th, 2007, 2007PDD23000002 

 

 

4-43 

„

 

This error message means that there is RET command in Macro. RET command should be used for 

sub-macro to return program. It means that the program does not finish. If the program needs to be 

finished in Macro, please use END, not RET.  

„

 

The user can read error messages by macro. Once there is an error and the user execute’s a correct 

command before reading error message, the error message will be overwritten. When executing each macro, 

each Macro error message will not be influenced by another macro.  

„

 

This message means that there is GOTO error in macro.  

„

 

This message means that stack in macro is full. That may be cause by using too many sub-macros or 

execute different macros at the same time. This is to avoid insufficient memory.  

„

 

This is CALL sub-macro error. The sub-macro that is called should not be an empty sub-macro. This 

message is to avoid unexpected error.  

„

 

This is data read error. Sometimes this may be caused by memory data error but most of the time is the 

controller data read error.  

„

 

This is data write error. Sometimes this may be caused by memory data error but most of the time is 

the controller data write error.  

„

 

This error message means that the devisor is 0 when performing division operation.