Maretron ALM100 Manual De Usuario

 

Sounder Collar

Volume Control Shutter 

Volume Control Baffle Plate 

ALM100 Alarm Module 

Volume Control Screw

ALM100 Faceplate  

Faceplate Gasket

Sounder Gasket 

ALM100 Mounting Screws (x2) 

NMEA 2000 Cable (not 

included)

Faceplate 

Mounting Screws 

(x2) 

 

 
The following instructions apply wither mounting the ALM100 into an electrical box or to a wall: 

1)  Connect the NMEA 2000 cable to the connector on the ALM100 Alarm Module 
2)  Using the included ALM100 mounting screws, mount the ALM100 Alarm Module to the 

wall or electrical box 

3)  Place the sounder gasket over the sounder on the ALM100 alarm module 
4)  Place the faceplate gasket over the ALM100 alarm module 
5)  Mount the ALM100 faceplate over the ALM100 alarm module using the included 

faceplate mounting screws. 

6)  Screw the sounder collar onto the sounder of the ALM100 alarm module, which should 

now be protruding through the large hole in the faceplate, and tighten until snug. 

7)  Optionally, you may install the volume control by first placing the volume control baffle 

plate over the front of the sounder, then placing the volume control shutter over the 
volume control baffle plate, and finally attaching both to the sounder by threading the 
volume control screw into the hole in the center of the sounder. 

 

The ALM100 requires a single type of electrical connection: the NMEA 2000

®

 connection (refer 

to Section 2.4.1). 
 

The NMEA 2000

®

 connector can be found on the rear of the enclosure. The NMEA 2000

®

 

connector is a round five pin male connector (see Figure 3). You connect the ALM100 to an