LSI 1600 Manual De Usuario

                                                                                                                                                                        Chapter 4 Features

Operating System Drivers  MegaRAID includes a DOS software configuration utility and drivers for all major

operating systems. See the MegaRAID Operating System Drivers Guide for additional information.

The DOS drivers for MegaRAID are contained in the firmware on MegaRAID except the DOS
ASPI and CD-ROM drivers. Call LSI Logic Technical Support at 678-728-1250 or access the web
site at www.lsil.com for information about drivers for other operating systems.

Card Size

12.3" x 4.2" (half length PCI)

Processor

Intel i960RN @ 100 MHz

Bus Type

PCI 2.2

Bus Data Transfer Rate

Up to 266 MB/s

BIOS

MegaRAID BIOS

Cache Configuration

16, 32, 64, or 128 MB through a single bank using
66 MHz, 3.3V unbuffered ECC SDRAM in a
single-sided or double-sided 168-pin DIMM.

Firmware

1 MB × 8 flash ROM

Nonvolatile RAM

32 KB × 8 for storing RAID configuration

Operating Voltage

5.00 V ± 0.25 V and 3.30V +/- 0.3V

SCSI Controller

Two SCSI controllers for 160M and Wide support

SCSI Data Transfer

Rate

Up to 160 MB/s

SCSI Bus

Low-voltage differential or SE

SCSI Termination

Active

Termination Disable

Automatic through cable detection

Devices per SCSI

Channel

Up to 15 wide or seven non-wide SCSI devices. Up
to 6 non-disk SCSI drives per MegaRAID
controller.

SCSI Device Types

Supported

Synchronous or Asynchronous. Disk and non-disk.

RAID Levels Supported

0, 1, 3, 5,10, 30, and 50

SCSI Connectors

Two 68-pin internal high-density connectors for 16-
bit SCSI devices.
Four ultra-high density 68-pin external connectors

SCSI cables

Up to 25 meters if using low voltage differential

Serial Port

9-pin RS232C-compatible berg