Raritan Computer EMX2-111 Manual De Usuario
Chapter 3: Getting Started
49
Asset Management Information
The LCD display can display the asset sensor state on each FEATURE
port as well as the asset tag state of each rack unit. For the Raritan asset
sensor, a rack unit refers to a tag port.
port as well as the asset tag state of each rack unit. For the Raritan asset
sensor, a rack unit refers to a tag port.
To display the asset management information:
1. Press the MODE button until the term "ASSET" is displayed in the
top-right corner of the LCD display.
2. Press the Up or Down button until the desired FEATURE port
number is displayed in the top of the LCD display. See
LCD Display
(on page 45).
Pressing the (UP) button moves up one selection.
Pressing the (DOWN) button moves down one selection.
If no asset sensor is detected or physically connected to the selected
FEATURE port, the term "nA" appears.
FEATURE port, the term "nA" appears.
Note: Press and hold the Up or Down buttons for at least two (2)
seconds to quickly move through several items at once.
seconds to quickly move through several items at once.
3. Press the FUNC button. When an blinking double-arrow symbol
appears on the left side of the LCD display, press the Up or Down
button to select the desired rack unit on the currently selected asset
sensor. The rack unit number appears in the middle of the LCD
display.
button to select the desired rack unit on the currently selected asset
sensor. The rack unit number appears in the middle of the LCD
display.
If the term "ALARM" appears below the rack unit number, it
means no asset tag is detected or physically connected to that
rack unit.
rack unit.
If the term "ALARM" does NOT appear, it means a connected
asset tag is detected on the rack unit.
IP Address
The IP Address is also available in the EMX LCD display. Use the Mode
button to switch between sensor, asset and device mode. When in
device mode, a small "d" is displayed in the upper left corner. The
address starts with the IPv4 address, indicated by "i4" in the upper right
corner of the display. Use the Function button to switch to the MAC
address, in which case an "M" is displayed in the upper right corner.
button to switch between sensor, asset and device mode. When in
device mode, a small "d" is displayed in the upper left corner. The
address starts with the IPv4 address, indicated by "i4" in the upper right
corner of the display. Use the Function button to switch to the MAC
address, in which case an "M" is displayed in the upper right corner.