Renesas E6000 Manual De Usuario
1 / 4
HS3160EPI60HE-P(C)
Precautions on Using the H8/3160 Series E6000 Emulator
This section shows notes on using the H8/3160 Series E6000 Emulator.
1 Precautions on Using the Emulator
1.1 Note on Compatibility of Session File
There is the following note on a session file that has been created at emulation of the H8/3164 device.
• The session file, which has been created with H8/3160 E6000 Emulator HDI System V3.30 or earlier
version, cannot be loaded with H8/3160 E6000 Emulator HDI System V3.30 or later version.
(The 'Invalid target system E6000 H8/3164 Emulator' message is displayed.)
(The 'Invalid target system E6000 H8/3164 Emulator' message is displayed.)
To solve this problem, a session file should be edited.
Open a session file (having the '.hds' or '.hdt' extension) by using a text editor (such as Notepad), and
replace and save the character string 'H8/3164' in the session file as 'H8/3164(AE350)'.
Open a session file (having the '.hds' or '.hdt' extension) by using a text editor (such as Notepad), and
replace and save the character string 'H8/3164' in the session file as 'H8/3164(AE350)'.
1.2 MAP
• Modification of MAP attribution
Reserved area from address H’FFD0 cannot be changed to emulation memory.
1.3 Trace
The code display is invalid when address range is specified as a trace acquisition condition. Use the code
display only for reference.
display only for reference.
1.4 Temporary Breakpoint
• Run... (Run menu)
Do not set temporary breakpoints to an area wherein PC Break (Not used area) cannot be set. If set, user
program execution will not stop at the breakpoint. Moreover, the On Chip Breakpoint may remain. In this
case, delete the breakpoint from the [Breakpoints] window.
program execution will not stop at the breakpoint. Moreover, the On Chip Breakpoint may remain. In this
case, delete the breakpoint from the [Breakpoints] window.
1.5 Monitor
• Execution status display on status bar
At memory access wait, not the address where access is halted, but the next fetched address is displayed.
1.6 The Load/Save of the Session File
Load the file after you confirm that the H/W environment is the same as that when the last session file was
loaded.
Note that the operation of HDI may become incorrect when Target Clock is chosen at the time when the
session file was saved and Target was not connected at the time when the session file was loaded.
loaded.
Note that the operation of HDI may become incorrect when Target Clock is chosen at the time when the
session file was saved and Target was not connected at the time when the session file was loaded.
1.7 Load Memory
During loading memory, if loading is stopped by [Halt] from the [Run] menu, there may be no responses
from the HDI for a few seconds. For loading file, use [Load Program] from the [File] menu.
from the HDI for a few seconds. For loading file, use [Load Program] from the [File] menu.
Note: Microsoft
®
, Windows
®
, Windows
®
95, Windows
®
98, Windows NT
®
, and Windows
®
2000 are registered
trademarks of Microsoft Corporation in the United States and/or other countries.