HP (Hewlett-Packard) YELLOWJACKET PLUS Manual De Usuario
Page 4
Yellowjacket Main Screen
Yellowjacket PLUS main screen allows access to all software
menus. Use the stylus or the joystick to make a selection. You
can back up and access the main screen anytime by pressing
the joystick UP, DOWN, LEFT or RIGHT (the direction is indi-
cated at the bottom of the page.
menus. Use the stylus or the joystick to make a selection. You
can back up and access the main screen anytime by pressing
the joystick UP, DOWN, LEFT or RIGHT (the direction is indi-
cated at the bottom of the page.
Note that the firmware and serial number in the upper left
corner appears indicating serial connection between the iPAQ
and the Yellowjacket receiver.
corner appears indicating serial connection between the iPAQ
and the Yellowjacket receiver.
RTC MARKER MODE
YellowjacketPLUS uses the internal real-time clock of the iPAQ for timing.
In addition, there is a marker that starts at 0. By pressing the button to the
right of the marker value, the marker increases by 1. These values are
stored in any log files created for later conversion by Chameleon.
In addition, there is a marker that starts at 0. By pressing the button to the
right of the marker value, the marker increases by 1. These values are
stored in any log files created for later conversion by Chameleon.
Yellowjacket Options Screen
Press the iPAQ’s joystick to the right when in the Main Screen
to access this options screen. Here, you may turn on logging
and clear it from memory, enable security, enable all STAtion
mode and enable Dolphin™ Mapping Interface.
to access this options screen. Here, you may turn on logging
and clear it from memory, enable security, enable all STAtion
mode and enable Dolphin™ Mapping Interface.
Note:
Logging mode will only log data from the screen (mul-
tipath, spectrum, utilization, etc.) you are currently running.
The data file containing all data collected when logging is
turned ON is called LOG.YJ3.
The data file containing all data collected when logging is
turned ON is called LOG.YJ3.
Note:
Security mode should only be enabled after the user
has set the authorized MAC addresses in the security screen.
Otherwise, all APs detected will be seen as ‘unauthorized’ and
set off the security alarm until it is disabled.
Otherwise, all APs detected will be seen as ‘unauthorized’ and
set off the security alarm until it is disabled.
Note:
Dolphin Realtime Mapping software requires
YellowjacketPLUS’ internal GPS receiver option and a laptop
with a USB connection. Do not enable this option unless you
have the appropriet software, hardware and want to map your
802.11b study in real-time.set off the security alarm until it is
disabled.
with a USB connection. Do not enable this option unless you
have the appropriet software, hardware and want to map your
802.11b study in real-time.set off the security alarm until it is
disabled.
Note: Users should normally see genuine
firmware and serial numbers on this screen
when Yellowjacket is functioning properly.
If your firmware and serial number appear
as 0.00 and XXXXXX, then the iPAQ soft-
ware is not communicating properly with
the Yellowjacket receiver. Try troubleshoot-
ing procedures found in this user’s manual.