Motorola SG2-DRT-3X Manual De Usuario

Table 1 provides information on the user-related features of the SG2-DRT-3X. 

 

This test point enables monitoring of the optical output level of the module. 
The nominal scale factor is 1.0 V/mW (6.3 V equates to 8 dBm). The optical 
power test point does not track changes in optical power due to the laser 
tracking error. 

 

A red (

FAULT

) LED indicates that the laser output power is below normal 

limits. 
A green LED (

ON

) indicates the transmitter is enabled. 

Because the laser output requires a short period of time to stabilize, it is 
normal for neither LED to illuminate for approximately 10 seconds. The 
module must be enabled for the fault indicator to function. 

 

This MCX connector provides the SG2-DRT-3X with channel A RF input 
through a cable connection to the node lid board in an SG2440 or the E-pack 
in an SG2000. 

 

This MCX connector provides the SG2-DRT-3X with channel B RF input 
through a cable connection to the node lid board in an SG2440 or the E-pack 
in an SG2000. 

Channel C RF input is provided by direct connection of the node lid board 
with the D-type connector on the bottom of the SG2-DRT-3X. 

 

This SC/APC-type connector provides optical output from the SG2-DRT-3X. 

Figure 3 illustrates a side view of the SG2-DRT-3X and indicates the laser warning label. 

INVISIBLE LASER RADIATION WHEN OPEN

PEAK POWER 10 mW

CLASS  LASER PRODUCT

I

CHAPTER 1 SUBCHAPTER J

THIS PRODUCT COMPLIES WITH 21CFR

DANGER