Multi-Tech Systems FF420 Manual De Usuario

Chapter 2: Installation 

Multi-Tech Systems, Inc. 

FaxFinder Admin User Guide 

15 

After power is applied, the Power LED comes on immediately but there is a 4-second delay before the 
Status LED comes on.  In normal operation, the Status LED will be flashing. 

When you apply power, the FaxFinder performs a diagnostic self-test. The Status indicator flashes when 
the test is complete and the unit is ready.  If this does not happen, check that the power supply is solidly 
connected and that the AC outlet is live. 

Plug one end of your RJ45 Ethernet cable into the FaxFinder’s Ethernet jack and the other end into your 
network Ethernet hub.  This Ethernet cable is not included with your FaxFinder unit.  

: Before connecting to the Ethernet Network, make sure that the network to which you are 

connecting the FaxFinder is not a 192.168.2.x subnet.  Because the FaxFinder’s factory default 
IP address is 192.168.2.1, connecting it to a network that has a different device at that same IP 
address would cause data interference. 

If it is a 192.168.2.x subnet, connect from the Administrative PC to the FaxFinder using an RJ45 
crossover cable until the FaxFinder’s IP address has been configured.  Thereafter, connect the 
FaxFinder into the network with an ordinary RJ45 cable. 

FF-120/220

LNK

IOO

FF-420/820

R

FF-120/220

FF-420/820