Acer R500 Manual De Usuario
3 Setting up your system
30
Turning on your system
After making sure that you have set up the system properly and
connected all the required cables, you can now power on your system.
connected all the required cables, you can now power on your system.
To power on the system, press the power button on the front panel.
The system starts up and displays a welcome message. After that, a
series of power-on self-test (POST) messages appears. The POST
messages indicate if the system is running well or not.
The system starts up and displays a welcome message. After that, a
series of power-on self-test (POST) messages appears. The POST
messages indicate if the system is running well or not.
Note: If the system does not turn on or boot after pressing the
power button, go to the next section for the possible causes of the
boot failure.
power button, go to the next section for the possible causes of the
boot failure.
Aside from the POST messages, you can determine if the system is in
good condition by checking if the following occurred:
good condition by checking if the following occurred:
•
Power indicator on the front bezel lights up (green)
•
Power, Num Lock, and Caps Lock indicators on the keyboard light
up
up
Power-on problems
If the system does not boot after you have applied power, check the
following factors that might have caused the boot failure.
following factors that might have caused the boot failure.
•
The external power cable may be loosely connected.
Check the power cable connection from the power source to the
power cable socket on the rear panel. Make sure that the cable is
properly connected to the power source and to the power cable
socket.
power cable socket on the rear panel. Make sure that the cable is
properly connected to the power source and to the power cable
socket.
•
No power comes from the grounded power outlet.
Have an electrician check your power outlet.
aa r500.book Page 30 Thursday, September 20, 2001 11:06 AM