Cisco Systems 7500 Series Manual De Usuario

instead of the enable password when it exists.

Enter enable secret: barney

The enable password is used when there is no enable secret

and when using older software and some boot images.

Enter enable password: betty

Enter virtual terminal password: fred

Configure SNMP Network Management? [yes]:

Configure AppleTalk? [no]: y

Configure CLNS? [no]: 

Configure IPX? [no]: 

Configure Vines? [no]:

Configure XNS? [no]:

Configure DECnet? [no]:

Configure CLNS? [no]:

Configure bridging? [no]:

Configure IP? [yes]:

Configure IGRP routing? [yes]: 

      Your IGRP autonomous system number [15]: 

Configure Apollo? [no]: 

Save your settings to NVRAM. (For more information on saving settings to NVRAM, see the 

This section provides procedures for configuring interfaces to allow communication over a LAN or 
WAN. To configure the interface parameters, you will need your interface network addresses and subnet 
mask information; consult your network administrator for this information.

Use the following procedure to configure an Ethernet interface:

In the following example, the system is being configured for an Ethernet LAN using IP. Respond as 
follows to the setup prompts, using your own addresses and mask:

Configuring interface parameters: 

Configuring interface Ethernet0/0:

Is this interface in use? [no]: yes

Configure IP on this interface? [no]: yes

IP address for this interface: 10.1.1.10

Number of bits in subnet field [0]:

Class A network is 10.0.0.0, 0 subnet bits; mask is 255.0.0.0

Determine if you are going to enable IPX on this interface. If yes, enter the unique IPX network number:

Configure IPX on this interface? [no]: yes

    IPX network number [2]:

Enter yes if you want to use AppleTalk on the interface; enter yes to configure for extended AppleTalk 
networks, and then enter the cable range number and the zone name that is to be associated with your 
local zone:

Configure appletalk on this interface? [no]: yes