Cisco Systems 7500 Series Manual De Usuario

09

Do not use secondary bootstrap

08

Break disabled

07

OEM disabled

06

Ignore configuration disabled

05

Fast boot disabled

04

Fan boot disabled

03-00

Boot to ROM monitor

If the prompt is “rommon1”, the confreg command displays the virtual configuration register currently 
in effect. It includes a description of the bits. See the following sample output:

rommon 1 > confreg

Configuration Summary

enabled are:

load rom after netboot fails

console baud: 9600

boot: the ROM Monitor

Do you wish to change the configuration? y/n  [n]

The configuration register can be set in the configuration mode with the config-register 0x<value> 
command. See the following sample output:

Router# config t

Enter configuration commands, one per line. End with CNTRL/Z.

Router(config)#config-register 0x2142

Router(config)#end

Router#

%SYS-5-CONFIG_I: Configured from console by console

If the prompt is “>”, the or0x<value> command sets the configuration register. See the following sample 
output:

>o/r 0x2102

>

If the prompt is “rommon1”, the confreg command sets the configuration register. It prompts the user 
about each bit. See the following sample output:

rommon 1 > confreg

Confiuration Summary

enabled are:

load rom after netboot fails

console baud: 9600

boot: the ROM Monitor

do you wish to change the configuration y/n 

[n]:

y

enable

“diagnostic mode”? y/n 

[n]: 

n

enable 

“use net in IP bcast address”? y/n

[n]: 

n

disable  “use rom after netboot fails”? y/n

[n]:

n

enable 

“use all zero broadcast”? y/n

[n]:

n

enable 

“break/abort has effect”? y/n

[n]:

n