Cisco Systems uBR10-LCP2-MC16C Manual De Usuario

It is not necessary to configure the cable interface line card if you are installing a replacement card in 
the identical slot. The system automatically downloads the necessary configuration information from the 
process routing enigne (PRE).

Connect all downstream and upstream coaxial cables to the cable interface line card, as necessary.

Configure the cable interface line card, if necessary. For information about configuring the cable 
interface line card, refer to the Cisco uBR10012 Universal Broadband Router Software Configuration 
Guide at the following URL:

The following section describes how to remove and replace a Cisco uBR-MC16x cable interface line card 
in the Cisco uBR10-LCP2 adapter card. 

Do not attempt to separate or remove the cable interface line card from the Cisco uBR10-LCP2 adapter 
card while the combined cards are inserted in the chassis. You must remove the card as a unit; then, 
separate the line card from the LCP2 adapter card on a lab bench or other area that protects against ESD 
damage. 

To prevent alarms from activating, you must administratively shut down a cable interface line card before 
hot swapping it. Refer to “Shutting Down and Restarting the Interface” in the Cisco uBR7200 Series 
Universal Broadband Router Software Configuration Guide at the following URL:

Refer to the release notes at the following URL:

Otherwise, inform the network administrator that this portion of the network will be temporarily 
interrupted. If the maintenance LED is on, you can remove the cable interface line card without affecting 
systems operations. 

The Cisco uBR-MC16S main board also includes a daughter card . This daughter card is an integral part 
of the card assembly and cannot be removed in the field.

Ensure that you are properly grounded before handling the line card.