Cisco Systems 3825 Manual De Usuario
4-48
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Chapter 4 Configuring the Cisco 3825 Mobile Wireless Edge Router in a RAN-O Solution with the Command-Line
Configuration Sequence
For example, the following command specifies the class as the llq-class.
Router(config-pmap)# class llq-class
When you enter the class command, you are in the class submode of the policy-map configuration mode.
Step 3
Allocate a percentage of bandwidth to be used for the prority queue.
Router(config-pmap-c)# priority percent
number
For example, the following command specifies a priority percent number of 99.
Router(config-pmap-c)# priority percent 99
Step 4
Associate the llq-policy with a default class map. The default class is used for non-priority traffic.
Router(config-pmap-c)# class
class
-
default
Step 5
Allocate the remaining bandwidth to the default class.
Router(config-pmap-c)# bandwitdh remaining percent
number
For example, the following command specifies the remaining bandwidth as 1 percent.
Router(config-pmap-c)# bandwidth remaining percent 1
Step 6
Limit the queue depth of the default queue.
Router(config-pmap-c)# queue-limit
number
For example, the following command limits the queue depth to 45.
Router(config-pmap-c)# queue-limit 45
Note
The queue limit on the default class should be less than the hold-queue specified on the multilink
interface.
interface.
Step 7
Exit the class map and policy map configuration modes.
Router(config-pmap-c)# exit
Router(config-pmap)# exit
For more information about these commands, see the Cisco IOS Quality of Service Solutions Command
Reference for your Cisco IOS Release.
Reference for your Cisco IOS Release.
Specify the Location of the Interface
Step 1
Enter interface configuration mode and specify the location of the interface.
Router(config)# interface atm
slot
/subslot/
port
For example, the following command specifies the location of the interface as ATM0/0.
Router(config# interface atm0/0/0
Step 2
Disable the IP address configuration for the physical layer interface.
Router(config-if)# no ip address