Cisco Systems WAP4410N Manual De Usuario
Setting Up the WAP4410N Wireless-N Access Point
Navigating the Utility
WAP4410N Wireless-N Access Point with Power Over Internet
16
5
•
VLAN & QoS—Configures the 802.1Q VLAN and the Quality of Service
(QoS) settings.
(QoS) settings.
•
Advanced Wireless Settings—Configures the access point’s more
advanced wireless settings (for example, load balancing and channel
bandwidth).
advanced wireless settings (for example, load balancing and channel
bandwidth).
AP Mode
This screen allows you to select the mode of operation for the access point. The
default mode is Access Point.
default mode is Access Point.
Administration
This screen allows you to manage the access point.
•
Management—Configures the password and Simple Network
Management Protocol (SNMP) settings.
Management Protocol (SNMP) settings.
•
Log—Configures the log settings.
•
Diagnostic—Allows you to perform diagnostic activities, which can be
useful in solving network problems.
useful in solving network problems.
•
Factory Default—Resets the access point to its factory default settings.
•
Firmware Upgrade—Upgrades the access point’s firmware on this screen.
•
Reboot—Reboots the access point.
•
Config Management—Saves and restores access point configuration.
Status
This screen allows you to view status information about your local network,
wireless networks, and network performance.
wireless networks, and network performance.
•
Local Network—Displays system information, including software and
hardware versions, MAC address, and IP address on the LAN side of the
access point.
hardware versions, MAC address, and IP address on the LAN side of the
access point.
•
Wireless—Displays wireless network settings including SSID, network
mode, priority setting, VLAN trunk, and wireless channel.
mode, priority setting, VLAN trunk, and wireless channel.