Cisco Systems WET610N Manual De Usuario
17
Troubleshooting
Linksys WES610N/WET610N
17
WES610N/WET610N
Your computer or other wired, Ethernet device cannot communicate with the
wireless router.
wireless router.
1. Access the bridge’s browser-based utility
2. On the Basic Wireless Settings screen, make sure the Network Name (SSID)
2. On the Basic Wireless Settings screen, make sure the Network Name (SSID)
matches the name of your wireless network
3. Make sure the security settings (WPA, WPA2, or WEP) match the security
settings of your wireless network
The bridge’s IP address needs to be changed.
If the bridge is connected to a network with a DHCP server (usually the network
router), then the bridge will obtain its IP address from the DHCP server If
there is no DHCP server, then the bridge will use its default, static IP address,
169.254.1.250
router), then the bridge will obtain its IP address from the DHCP server If
there is no DHCP server, then the bridge will use its default, static IP address,
169.254.1.250
If you want the bridge to always use a static IP address, then follow these
instructions:
instructions:
1. Access the bridge’s browser-based utility
2. Click the Network Setup tab
3. From the Network Connection Type drop-down menu, select Static IP
4. Complete the Static IP Address, Subnet Mask, and Default Gateway fields
5. Click Save Settings
2. Click the Network Setup tab
3. From the Network Connection Type drop-down menu, select Static IP
4. Complete the Static IP Address, Subnet Mask, and Default Gateway fields
5. Click Save Settings
The bridge-enabled computer or other wired, Ethernet device will not
communicate with another wireless-enabled device (such as a computer or
printer).
communicate with another wireless-enabled device (such as a computer or
printer).
Check the following:
•
Make sure the wireless-enabled device is on the same wireless network
as the computer or other wired, Ethernet device connected to the bridge
as the computer or other wired, Ethernet device connected to the bridge
•
Make sure that the same Network Name (SSID) is used for all devices on
the wireless network
the wireless network
•
Make sure all devices are on the same IP network, using compatible IP
addresses
addresses
The browser-based utility does not accept your password.
Check the following:
•
The password is case-sensitive Make sure that you are using the correct
case(s) when entering the password
case(s) when entering the password
•
If you forget your password, you can reset the bridge to its factory
defaults
defaults
Press and hold the bridge’s Reset button for approximately five seconds;
the password will be reset to its factory default, admin All other bridge
settings will be reset to the factory defaults as well (To access the
browser-based utility, enter admin in the Password field )
the password will be reset to its factory default, admin All other bridge
settings will be reset to the factory defaults as well (To access the
browser-based utility, enter admin in the Password field )
After you make changes through the browser-based utility, the new settings
are not displayed on-screen.
are not displayed on-screen.
On your web browser, click Refresh If the new settings are not displayed, then
follow these instructions:
follow these instructions:
1. Unplug the power adapter from the bridge
2. Wait five seconds, and then plug the power adapter back into the bridge
3. On your web browser, click Refresh
2. Wait five seconds, and then plug the power adapter back into the bridge
3. On your web browser, click Refresh
WEB
If your questions are not addressed here, refer to the Linksys
website at Linksys.com/support
website at Linksys.com/support
Troubleshooting