Cisco Systems EPC3925 Prospecto

Connect the RF coaxial cable to the 
Cable port on the modem and connect 
the other end to the cable outlet in your 
home.

For Ethernet, insert the Ethernet cable 
into an Ethernet port on your PC and 
then into the Ethernet port on the 
modem.

For USB, insert a USB cable (not included) into 
a USB port on your PC and then into the USB 
port on the modem.

Note: If your PC does not have the necessary 
USB driver, contact your service provider for 
assistance.

Plug the AC power 
cord into the wall.

Select either Ethernet or USB to connect to your PC.

•  An Ethernet cable is included with the cable modem.

•  You will need an optional USB cable (not included) if you 

want to connect your cable modem to a USB port on 
your PC.

Verify that you have an 
active cable connection.

Optional:  Use a two-way splitter and RF 
coaxial cable to connect your active cable 
to both a set-top and the modem.

Cut along the dotted line or make a photocopy of this template and tape to wall.

DPQ2160 DOCSIS 2.0

Cable Modem

Wall Mounting Template

 

Select a location within 5 feet (1.6 m) of an electrical outlet. 

 

Check that the selected electrical outlet cannot be interrupted by a wall 
switch.  

 

Use the supplied cables to connect the modem to your PC.  

 

Leave sufficient clearance between the bottom of the modem and the 
floor or shelving.

Note: Mounting hardware and tools are not included.

 

Two #6 screws

 

Two 1/4-inch (6 mm) drywall anchors  

 

Drill with 1/4-inch (6 mm) bit

 
Required for mounting to plywood or studs:

 

Two 1-inch (25 mm) wood screws with head diameter between 
3/16-inch and 1/4-inch (4.5 mm and 6 mm)

 

 

Drill with 1/8-inch (3 mm) bit

Use the template to position the modem 
and to drill holes for mounting it to the wall.

Use the appropriate screws for your wall 
material and remove the template.

Carefully position the modem onto the 
screws.

Insert the AC power cord into the 
Power input on the modem.