Cisco Systems WRP400 Manual De Usuario
ATA Voice Field Reference
Regional page
ATA Administration Guide
151
B
Voice tab > Regional page >
Ring and Call Waiting Tone Spec section
IMPORTANT: Ring and Call Waiting tones don’t work the same way on all phones.
When setting ring tones, consider the following recommendations:
When setting ring tones, consider the following recommendations:
•
Begin with the default Ring Waveform, Ring Frequency, and Ring Voltage.
•
If your ring cadence doesn’t sound right, or your phone doesn’t ring, change
your Ring Waveform, Ring Frequency, and Ring Voltage to the following:
your Ring Waveform, Ring Frequency, and Ring Voltage to the following:
-
Ring Waveform: Sinusoid
-
Ring Frequency: 25
-
Ring Voltage: 80V
Voice tab > Regional page >
Control Timer Values (sec) section
Ring7 Name
Name in an INVITE’s Alert-Info Header to pick distinctive
ring/CWT 7 for the inbound call.
ring/CWT 7 for the inbound call.
The default is Bellcore-r7.
Ring8 Name
Name in an INVITE’s Alert-Info Header to pick distinctive
ring/CWT 8 for the inbound call.
ring/CWT 8 for the inbound call.
The default is Bellcore-r8.
Ring9 Name
Name in an INVITE’s Alert-Info Header to pick distinctive
ring/CWT 9 for the inbound call. This field is for the
SPA2102 only.
ring/CWT 9 for the inbound call. This field is for the
SPA2102 only.
The default is Bellcore-r9.
Hook Flash Timer
Min
Min
Minimum on-hook time before off-hook qualifies as hook-
flash. Less than this the on-hook event is ignored. Range:
0.1–0.4 seconds.
flash. Less than this the on-hook event is ignored. Range:
0.1–0.4 seconds.
The default is 0.1.