Cisco Systems WRP400 Manual De Usuario
ATA Voice Field Reference
User page
ATA Administration Guide
216
B
Voice tab > User page >
Supplementary Service Settings section
The ATA device provides native support of a large set of enhanced or
supplementary services. All of these services are optional. The parameters listed
in the following table are used to enable or disable a specific supplementary
service. A supplementary service should be disabled if a) the user has not
subscribed for it, or b) the Service Provider intends to support similar service
using other means than relying on the ATA device.
supplementary services. All of these services are optional. The parameters listed
in the following table are used to enable or disable a specific supplementary
service. A supplementary service should be disabled if a) the user has not
subscribed for it, or b) the Service Provider intends to support similar service
using other means than relying on the ATA device.
CW Setting
Call Waiting on/off for all calls.
The default is yes.
Block CID Setting
Block Caller ID on/off for all calls.
The default is no.
Block ANC Setting
Block Anonymous Calls on or off.
The default is no.
DND Setting
DND on or off.
The default is no.
CID Setting
Caller ID Generation on or off.
The default is yes.
CWCID Setting
Call Waiting Caller ID Generation on or off.
The default is yes.
Dist Ring Setting
Distinctive Ring on or off.
The default is yes.
Secure Call Setting If yes, all outbound calls are secure calls by default.
The default is no.
Message Waiting
This value is updated when there is voice mail notification
received by the ATA device. The user can also manually
modify it to clear or set the flag. Setting this value to yes
can activate stutter tone and VMWI signal. This parameter
is stored in long term memory and will survive after reboot
or power cycle.
received by the ATA device. The user can also manually
modify it to clear or set the flag. Setting this value to yes
can activate stutter tone and VMWI signal. This parameter
is stored in long term memory and will survive after reboot
or power cycle.
The default is no.