Cisco Systems Cisco IOS XR Manual De Usuario

In the following example, the Management Ethernet interface on the RP in slot RP1 is configured with 
an IP address:

RP/0/RP0/CPU0:router# configure

RP/0/RP0/CPU0:router(config)# interface MgmtEth0/RP1/CPU0/0

RP/0/RP0/CPU0:router(config-if)# ipv4 address 10.1.1.1 255.255.255.0

RP/0/RP0/CPU0:router(config-if)# no shutdown

RP/0/RP0/CPU0:router(config-if)# commit

RP/0/RP0/CPU0:router(config-if)# end

RP/0/RP0/CPU0:router#

RP/0/RP0/CPU0:router# show interfaces mgmtEth 0/RP0/CPU0/0

MgmtEth0/RP0/CPU0/0 is up, line protocol is up 

  Hardware is Management Ethernet, address is 0011.93ef.e8ea (bia 0011.93ef.e8e)

  Description: Connected to Lab LAN

  Internet address is 10.1.1.1/24

  MTU 1514 bytes, BW 100000 Kbit

     reliability 255/255, txload Unknown, rxload Unknown

  Encapsulation ARPA,  loopback not set,

  ARP type ARPA, ARP timeout 04:00:00

  Last clearing of "show interface" counters never

  5 minute input rate 0 bits/sec, 0 packets/sec

  5 minute output rate 0 bits/sec, 0 packets/sec

     375087 packets input, 22715308 bytes, 87 total input drops

     0 drops for unrecognized upper-level protocol

     Received 297320 broadcast packets, 0 multicast packets

              0 runts, 0 giants, 0 throttles, 0 parity

     48 input errors, 43 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

     89311 packets output, 6176363 bytes, 0 total output drops

     Output 53 broadcast packets, 0 multicast packets

     0 output errors, 0 underruns, 0 applique, 0 resets

     0 output buffer failures, 0 output buffers swapped out

     0 carrier transitions

RP/0/RP0/CPU0:router(config)# end

Ends the configuration session and returns to EXEC 
mode.

rack

slot

port

RP/0/RP0/CPU0:router# show interfaces 

MgmtEth0/RP0/CPU0/0

Displays the interface details to verify the settings.