Cisco Systems CISCO7201 Manual De Usuario
2-3
Cisco 7201 Installation and Configuration Guide
OL-11364-04
Chapter 2 Installing the Cisco 7201 Router
Preparing to Install the Cisco 7201 Router
Tools and Parts Required
Your Cisco 7201 chassis is fully assembled at the factory; no assembly is required. However, you need
the following tools and equipment to install the chassis and the rack-mount and cable-management kit,
and the DC power supplies:
the following tools and equipment to install the chassis and the rack-mount and cable-management kit,
and the DC power supplies:
•
Number 2 Phillips screwdriver
•
A 3/16-inch flat-blade screwdriver
•
Tape measure (optional)
•
Level (optional)
•
Chassis grounding lug and wires:
–
A grounding lug with two number-10 screw holes with a 0.63-inch (16.002-mm) spacing
between them
between them
–
A wire receptacle large enough to accept a 6-AWG multistrand, copper wire
–
Two Phillips machine screws with locking washers—M5 (metric), 0.031-inch (.08-mm) pitch,
0.315-inch (8-mm) length
0.315-inch (8-mm) length
–
A crimping tool to fit the grounding lug wire receptacle
–
A wire stripper
–
One grounding wire—6-AWG, 0.162-inch (4.115-mm) diameter, with approximately
0.108-inch (2.743-mm) insulation, for a total wire diameter of approximately 0.27 inches
(6.858 mm). The wire length depends on your router location and site environment.
0.108-inch (2.743-mm) insulation, for a total wire diameter of approximately 0.27 inches
(6.858 mm). The wire length depends on your router location and site environment.
•
The rack-mount and cable-management kit (RCKMNT-7201) includes the following parts:
–
Two rack-mount brackets for mounting the chassis in the rack
–
One cable-management bracket
–
Four 6-32 x 0.25-in. screws to secure the rack-mount brackets to the chassis
–
Two M3 x 8-mm screws to secure the rack-mount brackets to the chassis
–
Four 10-32 or 12-24 screws to secure the rack-mount brackets to a 19-inch or 21–23-inch rack
–
One M4 x 20-mm screw to attach the cable-management bracket to the rack-mount bracket
•
For DC power supplies installation, the following parts:
–
Ratcheting torque screwdriver with a Phillips head that exerts up to 15 pound force-inches
(lbf in.) or 240 ounce force-inches (ozf in.) of pressure
–
Panduit crimping tool with optional controlled cycle mechanism
–
18-gauge copper ground wire (insulated or noninsulated)
–
Four leads of 18-gauge copper wire
–
Wire-stripping tool for stripping 18-gauge wire
In addition, you might need the following external equipment:
•
Ethernet transceiver
•
Token Ring multistation access unit (MSAU)
•
ESD-preventative wrist strap
•
Power cords
•
Appropriate cables to connect the router to the network, console, and auxiliary ports