Cisco Systems CISCO7201 Manual De Usuario
3-20
Cisco 7201 Installation and Configuration Guide
OL-11364-04
Chapter 3 Starting and Configuring the Router
Configuring a Cisco 7201 Router
enable secret 5 $1$u8z3$PMYY8em./8sszhzk78p/Y0
enable password betty
line vty 0 4
password fred
snmp-server community public
!
ip routing
no vines routing
ipx routing
appletalk routing
no apollo routing
no decnet routing
no xns routing
no clns routing
no bridge 1
! Turn off IPX to prevent network conflicts.
interface ATM1/0
ip address 1.1.1.10 255.0.0.1
appletalk cable-range 0-0 0.0
appletalk discovery
!
router igrp 15
network 1.0.0.0
!
end
Use this configuration? [yes/no]: yes
Building configuration...
Use the enabled mode ‘configure’ command to modify this configuration.
Press RETURN to get started!
Your router is now minimally configured and ready to use. You can use the setup command if you want
to modify the parameters after the initial configuration. To perform more complex configurations, use
the configure command.
to modify the parameters after the initial configuration. To perform more complex configurations, use
the configure command.
For information on additional interface configuration and specific system configurations, refer to the
modular configuration and modular command reference publications in the Cisco IOS software
configuration documentation set that corresponds to the software release installed on your Cisco
hardware.
modular configuration and modular command reference publications in the Cisco IOS software
configuration documentation set that corresponds to the software release installed on your Cisco
hardware.
Performing a Basic Configuration Using Global Configuration Mode
You can configure a Cisco 7201 router manually if you prefer not to use the setup facility or AutoInstall.
Complete the following steps to configure the router manually:
Complete the following steps to configure the router manually:
Step 1
Connect a console terminal to the console port.
Step 2
When asked if you want to enter the initial dialog, answer no to go into the normal operating mode of
the router:
the router:
Would you like to enter the initial dialog? [yes]: no