Manualsbrain.com
  1. Manuales
  2. Marcas
  3. Cisco Systems
  4. IPMUX-1E
  5. Manual De Usuario

Cisco Systems IPMUX-1E Manual De Usuario

Descargar
Página de 217
IPmux-1/1E Installation and Operation Manual 
Appendix E  Configuration Menus 
 
Connection Configuration: Static Mode 
E-29 
Bundle Connection Configuration: Static Mode   
BUNDLE CONNECTION CONFIGURATION 
1. Bundle ID   
1 
2. IP TOS 
 
1 
3. TDM Bytes in Frame (x48 bytes) 
1 
4. Connection Status 
Disable 
5. Destination IP Address 
0.0.0.0 
6. Next Hop 
 
0.0.0.0 
7. Destination Bundle 
1 
8. Jitter Buffer (x10 µsec) rounded up 1000 µsec steps! 300 
9. OAM Connectivity 
Disable 
A. Redundancy Function 
None 
B. VLAN Tagging  
Yes 
C. VLAN ID 
 
1 
E. VLAN Priority 
00 
ESC. Exit 
Calculated bundle throughput [BPS]: 3978080 
Select item from the menu. 
Figure E-32.  Bundle Connection Configuration (Static Mode)  
Parameters must be configured for each connection. To configure all parameters, 
first select the bundle ID and then proceed with the parameter configuration.  
 
•  First define the bundle. 
•  When changing the Destination IP Address, Next Hop, or Destination Bundle, 
the Connection Status must be set to Disable. After you save the changes, 
Connection Status can be reset to Enable.  
 
Table E-20.  Bundle Connection Parameters: Static Mode 
Parameter Possible 
Values 
Remarks 
Bundle ID 
1, 2 
If only one bundle is used, the Bundle ID must be 
configured as 1. 
IP ToS 
0
 to 255 
Type of Service – sets the IP ToS field in the IP 
frames transmitted by the device. 
ToS configuration configures the WHOLE byte, since 
different vendors may use different bits to tag 
packets for traffic prioritization. 
ToS assignment applies to all TDM packets leaving 
IPmux-1. 
Default configuration: 0 
VLAN ID and  
VLAN Priority are 
configurable only if 
VLAN Tagging is  
set to Yes. 
Main Menu 
↓ 
2. Configuration 
↓ 
3. Connection 
Configuration 
↓ 
2. Bundle 
Connection 
Configuration 
Note