Manualsbrain.com
  1. Manuales
  2. Marcas
  3. Cisco Systems
  4. IPMUX-1E
  5. Manual De Usuario

Cisco Systems IPMUX-1E Manual De Usuario

Descargar
Página de 217
Appendix E  Configuration Menus 
IPmux-1/1E Installation and Operation Manual 
E-32 
Connection Configuration: Dynamic CAS Mode 
 
Table E-21.  Protection Switching Configuration Parameters (Cont.) 
Parameter Possible 
Values 
Remarks 
Force Connection 
Disable, Primary, 
Secondary 
Valid only if primary and secondary bundles have 
been defined 
Recovery 
No (Non-Revertive), 
Yes (Revertive) 
Valid only if primary and secondary bundles have 
been defined 
Wait-To-Restore Time 
10 
to 99 
Valid only if primary and secondary bundles have 
been defined 
 
For the first 10 seconds after a switch between bundles, switching back is disabled – 
even if a threshold is exceeded. 
 
E.7  Connection Configuration: Dynamic CAS Mode   
 
To Configure the Connection:  
1. Select 1 to enter the Connection Mode. Use the <Space bar> to select 
Dynamic CAS
 and then press <Enter>.  
 
For Dynamic CAS: The E1/T1 Signaling Mode must be configured as CAS Enable. 
 
2. Enter the Bundle Connection Configuration data (described later in this 
section).  
 
The Bundle Connection Configuration menu for Dynamic CAS Mode differs from 
the menu used for Static Mode. 
 
3. Enter the Activation Criterion data (described later in this section).  
                   CONNECTION CONFIGURATION 
    1. Connection Mode                           Dynamic CAS 
    2. Bundle Connection Configuration             > 
    3. Activation Criterion                        > 
  ESC. Exit  
Figure E-34.  Connection Configuration  
Note 
Main Menu 
↓ 
2. Configuration 
↓
 
3. Connection 
Configuration 
Note 
Note