Cisco Systems Cisco CRS-1 Manual De Usuario
4-55
Cisco CRS-1 Carrier Routing System 4-Slot Line Card Chassis Installation Guide
OL-10971-07
Chapter 4 Installing and Removing SFCs, RPs, MSCs, PLIMs, and Associated Components
How to Install or Remove a Small Form-Factor Pluggable (SFP) Module
Required Tools and Equipment
You need the following tools to perform this task:
•
ESD-preventive wrist strap
•
Small flat-blade screwdriver
Steps
To remove a bale-clasp SFP module from a PLIM, follow these steps:
Step 1
Attach the ESD-preventive wrist strap to your wrist and connect its leash to one of the ESD connection
sockets on the front (PLIM) side of the chassis or a bare metal surface on the chassis.
sockets on the front (PLIM) side of the chassis or a bare metal surface on the chassis.
Step 2
Disconnect and remove all interface cables from the ports. Be sure to note the current connections of the
cables to the ports on the PLIM.
cables to the ports on the PLIM.
Step 3
Open the bale-clasp on the module with your index finger in a downward direction (see
). If
the bale-clasp is obstructed and you cannot use your index finger to open it, use a small screwdriver or
other long, narrow instrument to open the bale-clasp.
other long, narrow instrument to open the bale-clasp.
Step 4
Grasp the module between your thumb and index finger and carefully remove it from the port (see
Note
Be careful to hold the module in such a way so as to not damage the bale-clasp.