Cisco Systems Cisco CRS-1 Manual De Usuario
4-3
Cisco CRS-1 Carrier Routing System 4-Slot Line Card Chassis Installation Guide
OL-10971-07
Chapter 4 Installing and Removing SFCs, RPs, MSCs, PLIMs, and Associated Components
About Installing and Removing Cards and Associated Components
Figure 4-2
Operating Ejector Levers
Recommended Order for Installing Cards
Although it is not critical for you to install the cards in a certain order, following the card installation
recommendations in this section will make your installation process easier. We recommend that you
install cards in the Cisco CRS-1 4-slot chassis in the following order:
recommendations in this section will make your installation process easier. We recommend that you
install cards in the Cisco CRS-1 4-slot chassis in the following order:
•
Switch fabric cards (SFCs)
Caution
Removing more than one switch fabric card at a time can misalign the chassis and may damage the card
or chassis when reinserting the cards. Remove and reinsert only one card at a time.
or chassis when reinserting the cards. Remove and reinsert only one card at a time.
•
Route processors (RPs)
•
Modular services cards (MSCs)
•
Physical layer interface modules (PLIMs)
Note
See the instructions in this chapter for details on how to install the individual cards.
101406