Cisco Systems OL-31454-01 Manual De Usuario

This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that 
the protective device is rated not greater than: Maximum 15 A, 120 Vac or Maximum 10 A, 230 Vac 
Statement 1005

Take care when connecting units to the supply circuit so that wiring is not overloaded. Statement 1018

Hazardous network voltages are present in WAN ports regardless of whether power to the unit is OFF 
or ON. To avoid electric shock, use caution when working near WAN ports. When detaching cables, 
detach the end away from the unit first. Statement 1026

Installation of the equipment must comply with local and national electrical codes. Statement 1074

This unit is intended for installation in restricted access areas. A restricted access area can be 
accessed only through the use of a special tool, lock and key, or other means of security. 
Statement 1017

Blank faceplates and cover panels serve three important functions: they prevent exposure to 
hazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI) 
that might disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not 
operate the system unless all cards, faceplates, front covers, and rear covers are in place. 
Statement 1029

Follow these guidelines to ensure general safety: 

Keep the chassis area clear and dust-free during and after installation.

Keep tools and chassis components away from walk areas. 

Do not wear loose clothing that could get caught in the chassis. Fasten your tie or scarf and roll up 
your sleeves. 

Wear safety glasses when working under conditions that might be hazardous to your eyes. 

Do not perform any action that creates a hazard to people or makes the equipment unsafe.