Cisco Systems Broadband Access Center Manual De Usuario
2-8
Cisco Broadband Access Center for Cable Installation Guide 2.7
OL-19105-01
Chapter 2 Preparing to Install Components
Installation
Step 5
Select one of the two installation types:
•
Individual Components—This option enables you to install an RDU, Network Registrar extensions, the
DPE, or the KDC. See these sections for the appropriate installation instructions:
DPE, or the KDC. See these sections for the appropriate installation instructions:
–
–
–
–
•
Lab—This option enables you to install the software in a laboratory environment. See
in this guide.
Step 6
Click Next. Depending on the option you selected in the preceding step, either the Installation
Components screen appears, or you begin the lab installation.
Components screen appears, or you begin the lab installation.
Note
You must select one of the displayed installation components before you can proceed with the
installation.
installation.
Installing from the Command Line
To perform the initial installation procedure from the command line:
Step 1
Log into the intended BACC host as root.
Step 2
At the Solaris system prompt, change directory to your CD-ROM drive or other installation media. The
installation program, setup.bin, is at the root of this drive.
installation program, setup.bin, is at the root of this drive.
Step 3
Enter this command to start the installation program:
> setup.bin -console
The installation program verifies that you have installed the required patches to the Solaris operating
system. When the verification is complete, the program displays welcome information.
system. When the verification is complete, the program displays welcome information.
Step 4
Press Enter to continue. The program prompts you to choose the installation type. You can choose to
install:
install:
•
Individual components
•
Lab installation
Step 5
To choose individual components, enter C; or, to choose Lab installation, enter L. For example:
Choose Installation
Choose the type of BPR installation you want to install.
The Lab installation will store all components in the chosen destination.
Otherwise, you can select individual components and destinations.
Enter C for individual components or L for lab [C]:c