Cisco Systems Broadband Access Center Manual De Usuario

These commands described in this section, provide additional configuration settings. Changing these 
properties on the DPE-590 causes the change to take effect immediately, without a DPE restart. If you 
are working with a lab install, and modify any DPE property, you must restart the DPE for the change 
to take effect.

packetcable registration encryption—This command optionally enables encryption of the MTA 
configuration file.

dpe.properties: /pktcbl/regsvr/configEncrypt=1

no packetcable registration encryption—This command optionally disables encryption of the 
MTA configuration file. 

dpe.properties: /pktcbl/regsvr/configEncrypt=0

packetcable snmp timeout <timeout>—This command dynamically sets the number of seconds 
that the DPE waits for a response to an SNMPv3 SET operation.  The timeout is expressed in 
seconds and the default value is 10 seconds.

dpe.properties: /pktcbl/snmp/timeout=1 and /pktcbl/snmp/timeout=10

Complete these steps to verify that your DPEs are operating properly after configuring them for 
operation with voice technology.

Enter this command to collect all the log, property, and network configuration files on the DPE :

This command places the collected log files in the /outgoing directory. From there, the bundle is 
accessible using FTP.

Enter this command to check the status of both the DPE and voice technology settings:

BPR Agent is running

dpe is running

Version BPR 2.5 (cbpr_25_L_200302040515).

Caching 51970 device configs and 2 external files.

Received 312 cache hits and 0 misses.

Received 0 lease updates.

Connection status is Disconnected.

Sent 77 SNMP informs and 77 SNMP sets.

Received 77 MTA provisioning successful SNMP informs.