Cisco Systems ASR 1000 Series Manual De Usuario
B-20
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide
OL-13208-03
Appendix B Troubleshooting Initial Startup Problems
Replacing or Recovering a Lost Password
Step 8
Change the configuration register back to its original setting.
Details of the Password Recovery Procedure
Complete the following steps to recover or replace a lost enable, enable secret, or console login
password:
password:
Step 1
Attach an ASCII terminal to the console port on your router.
Step 2
Configure the terminal to operate at 9600 baud, 8 data bits, no parity, and 1 stop bit (9600 8N1).
Step 3
If you can log in to the router as a nonprivileged user, enter the show version command to display the
existing configuration register value. Note the value for use later and proceed to Step 6. If you cannot
log in to the router at all, go to the next step.
existing configuration register value. Note the value for use later and proceed to Step 6. If you cannot
log in to the router at all, go to the next step.
Step 4
Press the Break key or send a Break from the console terminal. If Break is enabled, the router enters the
ROM monitor, indicated by the ROM monitor prompt (rommon1>). Proceed to Step 6. If Break is
disabled, power cycle the router (turn the router off or unplug the power cord, and then restore power
after waiting 30 seconds). Then proceed to Step 5.
ROM monitor, indicated by the ROM monitor prompt (rommon1>). Proceed to Step 6. If Break is
disabled, power cycle the router (turn the router off or unplug the power cord, and then restore power
after waiting 30 seconds). Then proceed to Step 5.
Step 5
Within 60 seconds of restoring the power to the router, press the Break key or send a Break. This action
causes the router to enter the ROM monitor and display the ROM monitor prompt (rommon1>).
causes the router to enter the ROM monitor and display the ROM monitor prompt (rommon1>).
Step 6
Set the configuration register using the configuration register utility; enter the config command at the
ROM monitor prompt as follows:
ROM monitor prompt as follows:
rommon1> config
Step 7
Answer yes to the enable ignore system config info? question, and note the current configuration register
settings.
settings.
Step 8
Initialize the router by entering the reset command as follows:
rommon2> reset
The router initializes, the configuration register is set to 0x142, and the router boots the system image
from flash memory and enters the System Configuration Dialog prompt as follows:
from flash memory and enters the System Configuration Dialog prompt as follows:
--- System Configuration Dialog --
Step 9
Enter no in response to the System Configuration Dialog prompts until the following message is
displayed:
displayed:
Press RETURN to get started!
Step 10
Press Return. The user EXEC prompt is displayed as follows:
Router>
Step 11
Enter the enable command to enter privileged EXEC mode. Then enter the show startup-config
command to display the passwords in the configuration file as follows:
command to display the passwords in the configuration file as follows:
Router# show startup-config