Cisco Systems ASR 1000 Series Manual De Usuario
2-26
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide
OL-13208-03
Chapter 2 Cisco ASR 1000 Series Routers Components
Cisco ASR 1000 Series Router Power Supplies
Cisco ASR Router 1004 DC Power Supply
This section provides information about the DC power supplies on the rear of the Cisco ASR 1004
Router. For the maximum branch circuit for the DC power supply module, see
Router. For the maximum branch circuit for the DC power supply module, see
The DC power supply operates within specification from –48 VDC to –60 VDC continuously. The Cisco
ASR 1004 Router has two of the same type power supplies in power supply slot 0 and power supply
slot 1. The power supply slot numbers are on the left side of the chassis and the power supplies are
located on the floor of the chassis.
ASR 1004 Router has two of the same type power supplies in power supply slot 0 and power supply
slot 1. The power supply slot numbers are on the left side of the chassis and the power supplies are
located on the floor of the chassis.
The DC power supply input connector is a terminal block style that will allow crimp type lugs accepting
up to AWG #8 wire. The terminal block is compliant to all safety agencies and electrical requirements
of the supply. The terminal block accepts two-hole lugs (#10 stud) for all connections with center to
center spacing of 0.625 inches. A plastic cover goes over the terminal block to prevent accidental
contact. The connection order shall be negative (–), positive (+), and GND terminals.
up to AWG #8 wire. The terminal block is compliant to all safety agencies and electrical requirements
of the supply. The terminal block accepts two-hole lugs (#10 stud) for all connections with center to
center spacing of 0.625 inches. A plastic cover goes over the terminal block to prevent accidental
contact. The connection order shall be negative (–), positive (+), and GND terminals.
The unit requires a power switch circuit breaker to serve as the main disconnect for the DC input to the
power supply (
power supply (
see for current rating requirements.) The power supply unit is secured into the
system chassis with four captive screws mounted on the faceplate.
Cisco ASR 1004 Router DC Power Supply LEDs and Connector
ASR 1004 Router supports up to two power supplies. The power supply LEDs and connectors on the rear
of the chassis are described in the
of the chassis are described in the
.
FAN OK
Bi-color LED indicates
fan status
fan status
Green
LED illuminates green when all fans are operational.
Red
The LED illuminates red when a fan failure is detected.
OUTPUT FAIL
Power supply activity
Red
LED is red and turned off to signal that the DC output
voltages are within the normal operating range; output
voltage between the minimum and maximum limits will
not create an output fail alarm, and output voltages below
the minimum or above the maximum will create an output
fail alarm.
voltages are within the normal operating range; output
voltage between the minimum and maximum limits will
not create an output fail alarm, and output voltages below
the minimum or above the maximum will create an output
fail alarm.
When you turn the power supply on, the red LED is
illuminated for two to three seconds for testing LED
operation before going off.
illuminated for two to three seconds for testing LED
operation before going off.
LED Label
LED
Color
Description