Cisco Systems OL-20932-02 Manual De Usuario

The web administration pages appear, and are described in the following sections.

Enter the network settings to enable IP communication between the Gateway and the Cisco PAM 
appliance. Network settings include the following:

ETH0 Configuration: the ETH0 port provides IP network connectivity with the Cisco PAM 
appliance. 

DNS Configuration: enter a DNS configuration if names (not IP addresses) are used for the NTP 
or CPAM addresses.

Cisco PAM Configuration: defines the IP address and port of the Cisco PAM appliance that is used 
to manage the Gateway.

Gateway modules can be added to the IP network before or after the full module configuration is entered 
in Cisco PAM. For more information, see the 

.

Complete the following steps for each Gateway in the system.

Enter the ETH0 Configuration settings, as shown in 

. The ETH0 port is used for network 

communications with the Cisco PAM appliance.

If a Dynamic Host Configuration Protocol (DHCP) server is configured on your IP network, check 
the DHCP box for ETH0 to automatically configure the required IP network settings, including IP 
address, Subnet Mask, and Gateway. The DHCP check box is checked by default.

(Optional) If a DHCP server is not used to assign IP address settings, enter the following information 
in the ETH0 fields:

IP address: Enter the IP address of the Cisco Physical Access Gateway.

Subnet Mask: Enter the subnet mask.

Gateway: Enter the IP gateway address.