Cisco Systems OL-20932-02 Manual De Usuario

Each output port includes a status LED that indicates the following information: 

 

Output Interfaces

Eight Form C (5A @ 30V) relay outputs. Each output can be configured as either Normally 
Closed (NC) or Normally Open (NO).

C & NO connection: The relay is normally open. The circuit is closed when triggered.

C & NC connection: The relay is normally closed. The circuit is opened when triggered.

Install surge protection between the output device and the Cisco PAM module, as 
described in the 

.

Common (C) is always used, and either NC or NO is used to complete the connection.

All Generic Output devices installed in Cisco PAM systems prior to release 1.1.0, were 
connected to the Gateway, Reader, or Output modules with the wiring reversed. If 
upgrading to Cisco PAM release 1.1.0 from an earlier release, disconnect all Generic 
Output devices and do the following:

Connect Normally Open devices to the N.O. and C connectors on the Gateway, 
Reader, or Output module.

Connect Normally Closed devices to the N.C. and C connectors on the Gateway, 
Reader, or Output module.

PF

Power fail input: an unsupervised input that raises a “power fail” alarm when the circuit is 
open. Can be configured as an additional unsupervised port. An unsupervised input 
indicates only normal or alarm. The corresponding LED is red when circuit is open (when 
no input is connected).

TM

Tamper input: an unsupervised input that raises a “tamper” alarm when the circuit is open. 
Can be configured as an additional unsupervised port. An unsupervised input indicates only 
normal or alarm. The corresponding LED is red when circuit is open (when no input is 
connected).

Off

Output not configured

Solid Green

Output configured and in default state

Blinking Green

Output configured and active