Cisco Systems 1900 Series Manual De Usuario

Building configuration...

Use the enabled mode 'configure' command to modify this configuration.

Press RETURN to get started!

%LINK-3-UPDOWN: Interface Ethernet0/0, changed state to up

%LINK-3-UPDOWN: Interface Ethernet0/1, changed state to up

%LINK-3-UPDOWN: Interface Serial0/0/0, changed state to up

%LINK-3-UPDOWN: Interface Serial0/0/1, changed state to down

%LINK-3-UPDOWN: Interface Serial0/2, changed state to down

%LINK-3-UPDOWN: Interface Serial1/0, changed state to up

%LINK-3-UPDOWN: Interface Serial1/1, changed state to down

%LINK-3-UPDOWN: Interface Serial1/2, changed state to down

<Additional messages omitted.>

When the messages stop appearing on your screen, press Return to get the 

Router>

 prompt.

If you see the following message, it means that no other routers were found on the network 
attached to the port:

 

%AT-6-ONLYROUTER: Ethernet0/0: AppleTalk port enabled; no neighbors found

The 

Router>

 prompt indicates that you are now at the CLI and you have just completed the initial router 

configuration. Nevertheless, this is not a complete configuration. At this point, you have two choices:

Run the setup command facility again, and create another configuration.

Router> enable

Password: password

Router# setup

Modify the existing configuration or configure additional features by using the CLI:

Router> enable

Password: password

Router# configure terminal

Router(config)#

Use the Cisco Configuration Professional Express web-based application to configure the initial router 
settings. See 

Cisco Configuration Professional Express User Guide

 for detailed instructions.

For help with interface and port numbering, see the 

This section shows you how to access the CLI to perform the initial configuration on the router.

If the 

rommon 1>

 prompt appears, your system has booted in ROM monitor mode. For information on the 

ROM monitor, see