Cisco Systems OL-7396-01 Manual De Usuario

The following example shows how to enable and configure the time interval for interface, VC, and 
signaling counter updates between the primary and secondary route processors. 

Switch# configure terminal

Switch(config)# redundancy 

Switch(config-r)# main-cpu 

Switch(config-r-mc)# sync counters vc 60

Switch(config-r-mc)# sync counters interface 60

Switch(config-r-mc)# sync counters signaling

To display the route processor redundancy configuration, use the following privileged EXEC commands:

The following example shows the route processor redundancy configuration:

Switch# show redundancy

This CPU is the PRIMARY

Primary

-------

Slot:                          4

CPU Uptime:                    25 minutes

ILMI sysUpTime:                25 minutes

Image:                         PNNI Software (cat8540m-WP-M), Experimental

Version 12.1(20030605:120716) [mumahesh-counters-5june 163]

Time Since :

  Last Running Config. Sync:   21 minutes

  Last Startup Config. Sync:   21 minutes

Module Syncs are ENABLED

Init Sync is Complete

Interface counters syncs are DISABLED

VC counters syncs are DISABLED

Signaling counters syncs are DISABLED

Last Restart Reason: 

Switch Over 

Time since switchover:         1 minute 

Last Switchover duration:      52 seconds 

Secondary

---------

State:                         UP

Slot:                          8

Uptime:                        23 minutes

Image:                         PNNI Software (cat8540m-WP-M), Experimental

Version 12.1(20030605:120716) [mumahesh-counters-5june 163]

Switch#

Displays the redundancy configuration and status. 

Displays the current running configuration.