Cisco Systems OL-7396-01 Manual De Usuario

To configure a access filters on a two-ended soft PVP passive connection, follow these steps:

.

Using a source address —The following example shows the configuration of the two-ended soft PVP 
(shown in 

) with access control configured using a source address on the passive half leg. Start 

with the configuration of Switch-C.

Switch-C(config)# interface atm 0/0/1

Switch-C(config-if)# atm soft-vp 60 passive access-control src-address 

Switch-C(config-if)# end

Switch-C# 

On Switch-B, create a two-ended soft PVP on the source switch that uses the passive half leg on the 
terminating switch.

Switch-B(config)# interface atm 3/0/1

Switch-B(config-if)# atm soft-vp 50 dest-address 

Switch-C(config)# atm filter-set name [index 
[number]] [permit | deny] [template | time-of-day 
{anytime | start-time {end-time}}]

(Optional) Used to configure the access-control 
filter-set parameter on the passive 
destination-side of the soft VP.

Switch-C(config)# interface atm 
card/subcard/port

Switch-C(config-if)# 

Selects the interface, on the terminating switch, 
being configured.

Switch-C(config-if)# atm soft-vp dest-vpi 
passive [upc upc] [rx-cttr index] [tx-cttr index] 
[access-control {src-address atm-address | 
filter-set name}]

Configures the passive leg on the terminating 
switch interface.

Switch-B(config-if)# atm soft-vp source-vpi 

dest-address atm-address dest-vpi [enable | 
disable] [upc upc] [rx-cttr index] [tx-cttr index] 
[retry-interval [first retry-interval] [maximum 
retry-interval]]

Creates a two-ended soft PVP on the source 
switch that uses the passive half leg on the 
terminating switch.

Switch-C(config-if)# end

Switches to EXEC command mode.

Switch-C# show atm vp interface atm 

Displays the passive half-leg configuration 
information of two-ended soft PVP.